Allow the active timer (providing udelay() and currticks()) to be
selected at runtime based on probing during the INIT_EARLY stage of
initialisation.
TICKS_PER_SEC is now a fixed compile-time constant for all builds, and
is independent of the underlying clock tick rate. We choose the value
1024 to allow multiplications and divisions on seconds to be converted
to bit shifts.
TICKS_PER_MS is defined as 1, allowing multiplications and divisions
on milliseconds to be omitted entirely. The 2% inaccuracy in this
definition is negligible when using the standard BIOS timer (running
at around 18.2Hz).
TIMER_RDTSC now checks for a constant TSC before claiming to be a
usable timer. (This timer can be tested in KVM via the command-line
option "-cpu host,+invtsc".)
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Allow the link layer to directly report whether or not a packet is
multicast or broadcast at the time of calling pull(), rather than
relying on heuristics to determine this at a later stage.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Almost all FIP packets contain at most one instance of each
descriptor. A VLAN notification may contain multiple VLAN
descriptors. The FCoE specification does not provide any guidance
regarding prioritisation of VLANs, so we may choose to arbitrarily
choose the first listed VLAN.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
The increase in length in Fibre Channel device names causes the
"selected FCF" message to wrap beyond 80 characters. Fix by using
abbreviations where possible.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Create the Fibre Channel port only when the FCoE port has selected a
Fibre Channel Forwarder to use. This avoids the confusion of having
an FC port created for the network device on which only VLAN discovery
is performed.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
We currently set both the FP and SP bits in our FIP FLOGI, to allow
the FCF the choice of selecting either a fabric-provided or a server-
provided MAC address. This complies with the FCoE specification, but
has been observed to result in an FLOGI rejection from some FCFs.
Fix by recording whether or not the FCF supports SPMA, and requesting
only one of FPMA or SPMA in our FIP FLOGI. We choose to prefer SPMA
where available, because many iPXE drivers will not be able to receive
unicast packets sent to a non-default MAC address.
Reported-by: Hadar Hen Zion <hadarh@mellanox.co.il>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
FCoE requires the use of fabric-provided MAC addresses, which breaks
the assumption that the net device's MAC address is implicitly the
source address for net_tx() and the (unicast) destination address for
net_rx().
Signed-off-by: Michael Brown <mcb30@ipxe.org>
It seems as though several drivers neglect to strip the Ethernet CRC,
which will cause the FCoE footer to be misplaced and result
(coincidentally) in an "invalid CRC" error from FCoE.
Add a human-visible message indicating this, to aid in diagnosis.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Michael Brown